Our services
Inspection, heat treatment and certification for welds, castings, forgings, pressure vessels and piping.
Co-60 · Ir-192 · X-rayRadiography Testing
Gamma and X-ray imaging that shows the internal structure of welds and castings.
View service
Induction & furnaceStress Relieving
Induction and furnace post-weld heat treatment to remove residual stress safely.
View service
Wall thicknessUltrasonic Thickness Testing
Measures remaining wall thickness from one side to track corrosion and erosion.
View service
VTVisual Inspection
Lighting, measurement and comparison tools to verify design compliance.
View service
UTUltrasonic Flaw Detection
Sound waves locate and size sub-surface defects in welds, plates and forgings.
View service
DPTDye Penetrant Testing
Finds surface-breaking defects in any non-porous material.
View service
MPTMagnetic Particle Testing
Detects surface and shallow sub-surface flaws in ferromagnetic materials.
View service
Pressure vesselsSafety Audit & Material Handling
Inspection of metallic pressure vessels to find cracks and damage before failure.
View service
Portable & labMaterial Hardness Testing
Measures resistance to penetration to confirm strength and wear performance.
View service
Replica testingIn-situ Metallography
Examines microstructure on site to evaluate metallurgical damage.
View service
Boilers & pressure vesselsRemaining Life Assessment
Evaluates creep damage to decide on continued service, repair or replacement.
View service
Ranipet facilityHeat Treatment & Upgradation
Furnace heat treatment and shot blasting, single handling up to 15 MT.
View service
Material testing labMechanical Testing
Tensile, compression, impact and other tests to prove material properties.
View service
Indian Boiler RegulationsIBR Certification
Support for IBR compliance of boilers and boiler components.
View serviceNot sure which test you need?
Send us the drawing or material spec. Our Level III engineers will recommend the right method.
Ask an engineerFrom enquiry to signed certificate
The same five steps on every job.
- 1
Enquiry
Share drawings, material and location. We confirm scope and codes.
- 2
Planning
Technique, sources and safety plan for site or enclosure work.
- 3
Inspection
Certified technicians carry out testing with calibrated equipment.
- 4
Evaluation
Level II and III engineers interpret results against your code.
- 5
Report
Signed reports and certificates, ready for your client or IBR.
Need an inspection crew on site?
Tell us the job and location. A regional manager will call you back with a plan and a quote.